CONSTRUCTION:
Heavy gauge steel cabinet with powder coated finish and control compartment housing a master terminal board. The control compartment
allows for access through a hinged and latched door, simplifying wiring, installation, and maintenance. Made in U.S.A
HEATING ELEMENT:
The heating element is a copper clad steel sheath element with continuously brazed steel fins formed to allow side draw through air flow
OVERHEAT PROTECTION:
All units come equipped with manual reset type limit controls to de-energize the heater should an over-temperature situation occur
FAN and MOTOR:
Single speed, single phase permanently lubricated, thermally protected motors with ball bearings. The fan override purges the unit of residual
heat at shutdown
FIELD INSTALLED OPTIONS:
Summer fan switch to operate the fan only, and a heat stratification thermostat for high bay areas
HEATING STAGING:
60 KW and 70 KW are three stage; 80 KW, 90 KW, & 100 KW are four stage
SC5100 FACTORY INSTALLED ELECTRONIC STEP CONTROLLER
The optional factory installed step controller is a first on last off sequencer that will cycle the unit heater stages through an optional wall
thermostat. Additionally, the step controller can be controlled by any building management system with 4 to 20 MA or 0 – 10 VDC field
supplied control signal.
