Sale!

TPI F1F5510T Washdown Unit Heater – 10KW, 208V, 47.8 Amps, 5500 Series

Item # F1F5510T AKA # 7132502 UPC # 0686334713252 Brand: TPI

$5,886.08

-36%

You Save: $3310.92

Shipping options shown in Cart

Non-Returnable - Please double-check product specifications

Visa, MasterCard, Discover, American Express, PayPal | TrustPilot | SSL Secure

Enclosure and Motor:

Element housing shall be 16 gauge 304 or 316 stainless steel shroud. The outlet grill and louver assembly shall be 304/316 stainless steel and rotate for direction of discharge air. The heater shall have a 304/316 stainless steel inlet grill and fan guard. The motor shall be totally enclosed, permanently lubricated and designed to resist moisture and corrosion. The fan blade shall be aluminum with a powder coated epoxy finish.

Element:

The heating element shall be 304 or 316 stainless steel tube with 304/316 stainless steel fin material helically attached to the tube for even heat transfer. The element designed with the highest quality nickelchromium resistance wire embedded in compacted efficient dielectric to ensure proper heat transfer.

Control Panel

The control enclosure shall be non-metallic Nema 4X control panel watertight and dust- tight. The enclosure and elements are attached to the control panel with stainless steel fasteners. Standard control components are factory mounted and wired with access through control panel door on bottom of heater assembly. A standard door interlock disconnect switch shall be factory mounted and wired for safety

Controls:

All controls shall be factory mounted and wired in Nema 4X panel. Terminal block, 24 Volt transformer, high temperature limits, contactor and fusing if required by NEC are mounted and wired in control panel. A three-position switch (OffHeat-Fan) shall be mounted on side of control panel for access from outside of panel. A pilot light to indicate power is on for safety shall be located on side of control panel. A wall mounted Nema 4X thermostat is an optional accessory

A formed 304/316 stainless steel bracket shall be used on 3.3 thru 15 KW units. A cast iron epoxy painted bracket shall be used on 20 thru 48 KW units. Above brackets shall be combination wall/ceiling type. Optional mounting brackets are available

Additional information

Brand TPI
Weight 64 lbs
Dimensions 25 × 23 × 30 in
Also Known As

Item Type

Voltage

KW

BTU

Amps

Temp Change

Series

CFM

Control

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.